#
# this config file was automatically generated
# using lirc-0.6.1 on Fri Sep  1 22:34:30 2000
#
# contributed by Bastian
#
# brand:             pace
# model:             mss 300 serie
# supported devices: ?
#

# Pace remote controls send two header signals before the acutal
# code. The length of one header signal is approx. 750 3000. With the
# chosen tolerance values LIRC confuses the header signals with a
# 0. In this case this is ok, because otherwise you would have to
# create a raw_codes config file that does not support toggle
# bits. But it might cause problems if you want to send these signals.

begin remote

  name  pace
  bits           10
  flags SPACE_ENC|CONST_LENGTH
  eps            30
  aeps          100

  one           658  6930
  zero          658  4402
  ptrail        661
  pre_data_bits   2
  pre_data       0x0
  gap          121416
  toggle_bit      3


      begin codes
          1                        0x0000000000000301
          2                        0x0000000000000102
          3                        0x0000000000000303
          4                        0x0000000000000104
          5                        0x0000000000000305
          6                        0x0000000000000106
          7                        0x0000000000000307
          8                        0x0000000000000108
          9                        0x0000000000000309
          0                        0x0000000000000100
          Up                       0x000000000000031A
          Left                     0x0000000000000116
          Right                    0x0000000000000311
          Down                     0x000000000000010B
          Menu                     0x0000000000000317
          Ok                       0x000000000000011F
          Back                     0x000000000000030F
          Red                      0x000000000000010E
          Green                    0x000000000000030C
          Yellow                   0x0000000000000112
          Blue                     0x000000000000030D
      end codes

end remote
